Over 10,000 pages indexed!
redefining what an
engineering website should be.
(Seize the Day!)
My USAF radar shop
Hobby & Fun
Airplanes and Rockets:
My personal hobby website
My daughter Sally's horse riding business website - lots of info
My son-in-law's dog training business
|Measuring a Transmitter´s output Impedance components - RF Cafe Forums|
Because of the high maintenance needed to monitor and filter spammers from the RF Cafe Forums, I decided that it would
be best to just archive the pages to make all the good information posted in the past available for review. It is unfortunate
that the scumbags of the world ruin an otherwise useful venue for people wanting to exchanged useful ideas and views.
It seems that the more formal social media like Facebook pretty much dominate this kind of venue anymore anyway, so if
you would like to post something on RF Cafe's
page, please do.
Below are all of the forum threads, including all
the responses to the original posts.
Post subject: Measuring a Transmitter´s output Impedance components
Posted: Wed Dec 05, 2007 11:14 pm
Joined: Wed Dec 05, 2007 10:09 pm
I was asked to develop a linear amplifier for an RC transmitter (35MHz).
This transmitter uses a simple telescopic antenna, and now I will have to design the amplifier and adapt it´s output to a 50ohm transmission line and antenna.
So far so good, but then, as I started to analyze the problem, things started to complicate a little.
In order to adapt the amplifier´s input to the transmitter´s output, I need to know the transmitter´s output impedance components (resistive and reactive parts).
The resistive part should be something much lower then 50ohm, which is the typical impedance of short whip antennas (antennas bellow resonance).
I also know that short whip antennas present a natural capacitive reactance, and to counteract this, the transmitter has an inductive reactance part on it´s output to balance with the capacitive reactance of the antenna.
This is called Conjugate Matching and in order to adapt my amplifier´s input, I also need to know the magnitude of this inductive reactance.
Now, my question is:
How do I measure these values without using high priced equipment, like network analyzers?
Are there any techniques to do this, with an outside test setup made of variable capacitors, inductors and resistors and then measuring phase shifts, voltages and currents in some way on this setup, with an oscilloscope, that will allow us to calculate the resistive and reactive parts of the transmitter´s output impedance?
My intuition tells me that this is possible, but how?
I´ll appreciate any help.
Post subject: I gave you my suggestion in Circuit board.
Posted: Thu Dec 06, 2007 4:05 am
Joined: Sun Mar 19, 2006 5:25 pm
I gave you my suggestion in Circuit board where you posted your question first. Hope it is useful.