Because of the high maintenance needed to monitor and filter spammers from the RF Cafe Forums, I decided that it would
be best to just archive the pages to make all the good information posted in the past available for review. It is unfortunate
that the scumbags of the world ruin an otherwise useful venue for people wanting to exchanged useful ideas and views.
It seems that the more formal social media like Facebook pretty much dominate this kind of venue anymore anyway, so if
you would like to post something on RF Cafe's
page, please do.
Below are all of the forum threads, including all
the responses to the original posts.
Post subject: conductive angle Posted: Wed May 30, 2007 2:40 am
Tue May 02, 2006 4:59 am
How can I simulate by ADS the conductive angle of power
I finish the amplifier design and want to verify what class is it.
Post subject: Posted: Wed May 30, 2007 5:10 am
Joined: Mon Jun 27,
2005 2:02 pm
You need to run a transient simulation (Time
domain) on the output signal in which you will see the output waveform. By this you can find the conductance angle
and derive in which class your PA works.
Hope this helps!
Regards to all the folks.