Need specialist / expert advice on Antenna & Circuit Co- - RF Cafe Forums
Because of the high maintenance needed to monitor and filter spammers from the RF Cafe Forums, I decided that it would be best to just archive the pages to make all the good information posted in the past available for review. It is unfortunate that the scumbags of the world ruin an otherwise useful venue for people wanting to exchanged useful ideas and views. It seems that the more formal social media like Facebook pretty much dominate this kind of venue anymore anyway, so if you would like to post something on RF Cafe's Facebook page, please do.
Below are all of the forum threads, including all the responses to the original posts.
Post subject: Need specialist / expert advice on Antenna & Circuit Co- Posted: Fri Oct 07, 2005 4:05 am
Sub: Need specialist / expert advice on Antenna & Circuit Co-Simulation using Agilent ADS
Is it possible to co-simulate in Agilent ADS
Between HB (Nonlinear Circuit schematic) with Momentum (Antenna design).
Basically I want to vary the Power Levels dynamically for my antenna input &
monitor the radiation patterns simultaneously.
If not, is there any other tool does this job!!!
Post subject: Antenna and Circuit Co-simulationPosted: Wed Oct 12, 2005 5:28 pm
Your question implies a belief that the antenna's radiation patttern varies with power. This is not normally the case, which is why such simulations are usually done separately - both because they can be, and because there's a lot less work involved with splitting a system up and analyzing each piece.
Post subject: Posted: Fri Oct 14, 2005 1:51 am
It's the Fields not he radiation pattern...
I mean I should be able to see E & H fields when I cosimulate with circuit engine...
Is it possible???
More than 10,000 searchable pages indexed.