Dipole simulation with ansoft designer - RF Cafe Forums
Because of the high maintenance needed to monitor and filter spammers from the RF Cafe Forums, I decided that it would
be best to just archive the pages to make all the good information posted in the past available for review. It is unfortunate
that the scumbags of the world ruin an otherwise useful venue for people wanting to exchanged useful ideas and views.
It seems that the more formal social media like Facebook pretty much dominate this kind of venue anymore anyway, so if
you would like to post something on RF Cafe's
page, please do.
Below are all of the forum threads, including all
the responses to the original posts.
Post subject: Dipole simulation with ansoft designer
Posted: Tue Jan 24, 2006 4:03 am
Joined: Tue Jan 24, 2006
Location: Toulouse FRANCE
I'm trying to design a dipole antenna
with ansoft designer.
This dipole must be connected
to RFID CHIP.
I've separated the dipole into
two rectangle of lambda/4 (0.1mm separate them)
and i've selected the edges and add a port but the
software say "edges do not define a valid port".
In the help, i've found that:"The edges must
How can i simulate it???
Thanks You for your future Help
More than 10,000 searchable pages indexed.
Your RF Cafe
single-handedly redefining what an engineering website should be.
Progenitor & Webmaster
(Seize the Day!)
My USAF radar shop